When I press the clutch pedal in I feel a slight vibration. It's a fresh 350 rebuild, fresh M20 rebuild with new TA pilot bushing in my 72 Skylark 350. A new Falcon throw out bearing was also installed. When I installed it originally I had a problem where I didn't have the fork/bearing lined up correctly but corrected that and here is the original link. http://www.v8buick.com/index.php?threads/cant-move-clutch-fork-throwout-bearing-help.326025/ My guess is that I damaged the new throw out bearing slightly so I am going to pull the trans again, replace with another new falcon bearing and figured I would replace the fork as well since it was original. I bought this fork from Tamraz and doesn't look to be identical. Do you think it's correct and will work? https://www.ebay.com/itm/64-72-GM-A...e=STRK:MEBIDX:IT&_trksid=p2057872.m2749.l2649 Thanks
When the pressure plate was mounted to the flywheel, it might have been bolted on off center, like when you bolt a wheel on, you go from one side to the other till it is on. can't just tighten the bolts.