Tilt steering column

Discussion in 'Tips On Using The Board' started by GsProf0176, Apr 21, 2021.

  1. GsProf0176

    GsProf0176 Member

    Does anybody know what the torque specs are for the bolt on the "connector", "pinch clamp" that connects the top of the intermediate steering shaft to the bottom of the column mast shaft. Have the Helms service manual and doesn't mention it. Numerous videos etc on rebuilding replacing lower bearing and no one mentions the torque spec. Its a 7/16" fine thread bolt so I'm assuming its has to be in the 60-80 ft range. Thks
     

Share This Page