Prsssure plate, flywheel and bell torque specs

Discussion in 'U-shift em' started by tubecatgs, Sep 30, 2017.

  1. tubecatgs

    tubecatgs Finally a 4 speed......

    I found these specs on a few websites but do these look correct for my 72 350? Using factory original bolts.

    Flywheel 50 ft lbs
    Pressure plate 35 ft lbs
    Bell housing 35 ft lbs
     
  2. I would think at least 60 ft lbs on the flywheel. The rest looks correct. Just use blue loctite on all of your bolts. TA performance has these specs available if you're concerned
     

Share This Page