Nailhead powered Altered

Discussion in 'Cars for sale' started by DigDugMd, Jan 22, 2023.

  1. DigDugMd

    DigDugMd Active Member

    I am putting my Nailhead powered Altered up for sale due to health reasons. It is a drag race only car... not streetable. Engine is a 425 with new rod, main and cam bearings. Also has new Comp cam, lifters and roller timing set. Cylinder heads were hand ported and polished and have new TA valves, valve springs and hardware. Induction is a Hilborn stack injection manifold with a 1958 build date and matching Weiand cast aluminum front cover with pump drive. Ignition is handled by a vintage Vertex magneto which was recently rebuilt by Joe Hunt. Engine has not been fired since being refreshed. So, everything is new and ready to go. Transmission is a Turbo 400 with trans-brake, manual valve-body, custom stall converter, billet drums and input shaft.
    Chassis is a hand-built tube chassis, was NHRA certified to 7.50. Body is a one-piece fiberglass 23 T "turtledeck". Has brand-new heavy-duty drive shaft, Chrysler 8 3/4" rear with 4.88 gears and spool. Wilwood brakes with two 4 piston calipers per wheel. Vintage 15"X 10" Ansen Sprint aluminum rear wheels with 12" M&H Racemaster drag slicks. Front wheels are spindle mount aluminum spokes.
    I am asking $9000 for the car as is. It needs just a few things completed to make it race ready. I will sell the engine separately for $5000 and the rolling chassis for $4500.
     

    Attached Files:

  2. gs66

    gs66 Silver Level contributor

    Hope someone buys this and brings it to BG! GLWS!
     
    Waterboy likes this.
  3. Dennis S

    Dennis S Well-Known Member

    That car is very cool ….tough as nails.
     
  4. gsjohnny1

    gsjohnny1 Well-Known Member

    should have blower on it instead.
    but it looks to be a nice ride. i like it.
    interesting, but have an altered project already.
     
  5. Harpboys4

    Harpboys4 Well-Known Member

    where are you located
     
  6. DigDugMd

    DigDugMd Active Member

    Near Frederick MD................... a lonnnnnng way from SoCal
     
  7. BQUICK

    BQUICK Gold Level Contributor

    Did that run at 75/80? I remember one called PAC MAN. It had a Chevy motor then later a Stage 2 455. I have the heads on my car now......
     
    Dano likes this.
  8. gsjohnny1

    gsjohnny1 Well-Known Member

    too bad it isn't longer. twin nailhead engine altered. :eek::D
     
    Waterboy likes this.
  9. DigDugMd

    DigDugMd Active Member

    No, that was a different car. This one mainly ran Mason Dixon with a big block Mopar wedge back in the 90's to early 2000's. Chassis was originally a funny car built in the early 70's. Converted to an altered sometime in the 80's. Updated to meet NHRA 7.50 rules in the 90's with a new roll cage and a few extra braces.
     
  10. BQUICK

    BQUICK Gold Level Contributor

    OK, cool!
     
  11. Jim Weise

    Jim Weise EFI/DIS 482

    Very cool, and very reasonably priced.. wish I was in the market for an altered. I am sure it's going to put a smile on someones face.. good luck with the sale

    JW
     
    gs66 likes this.
  12. Babeola

    Babeola Well-Known Member

    What kind of ET/MPH expected with the nail?
     
    sean Buick 76 likes this.

Share This Page