If you ordered the T/A 2 1/2 Riviera exhaust for your Riv

Discussion in 'A boatload of fun' started by Jim68Skylark, Sep 20, 2004.

  1. Jim68Skylark

    Jim68Skylark Well-Known Member

    what mufflers did you go with?

    Could you give me the brand and part number please.

    Also did you go the resonator route before the tailpipe like the stock setup. If so, again please give me brand and part number.

    TIA :)
     
    Last edited: Sep 20, 2004
  2. 68_riv

    68_riv Active Member

    Dynomax super turbo mufflers. Summit number WLK-17748. Had to lengthen the head tubes to get the mufflers back far enough, but I think they have modified production to add the needed 3" or so. For the bracket just behind the mufflers I had to modify the original to take the 2 1/2" pipes since the supplied one hung the system too low. No resonators out back but I am planning to add some. Idle is too loud for me and there are some resonant noises just off idle that are beginning to bug me. Allow a good bit of time for fitting adjusting and fabricating. Tube bends are right on though.

    Keith
     
  3. Yardley

    Yardley Club Jackass

    I used the ones Dave at TA recommended. They are the long case ones 20" long I think. Can't remember which brand.
     
  4. 71GS455

    71GS455 Best Package Wins!

    Long case are usually the Walkers.
    The 17748's have an offset/centered setup for the tubes. The 17749's have an offset/offset for the tubes. I just picked up some 17749's for my Skylark. This will be the third car that has had them, and the fifth I've used the Walkers on (others were short case on 5.0 Mustangs).
     

Share This Page