Floor pans.. patch or replace?

Discussion in 'Color is everything!' started by George D., Sep 14, 2020.

  1. George D.

    George D. Platinum Level Contributor

    Began the prep to start welding and wire wheeled the floors to find a very small amount of rot in the floors. Other than what is pictured here, the floors are solid. So.. small patches or just replace the whole floor pan?

    Passenger side. Everything around these holes is solid..

    IMG_6292.jpg IMG_6287.jpg IMG_6250.jpg IMG_6251.jpg
     
  2. George D.

    George D. Platinum Level Contributor

    The driver's side is a little more inboard, due to the rear wiring harness channel...
    IMG_6253.jpg IMG_6256.jpg IMG_6253.jpg IMG_6256.jpg IMG_6289.jpg IMG_6291.jpg IMG_6293.jpg
     
  3. philbquick

    philbquick Founders Club Member

    From what I see I would patch it. You can buy sections in quarters, it looks like most is in the front. You may go over the pan with a pick hammer (sheet metal hammer) to see how many more places poke through before you make a final decision.
     

Share This Page