Cam Card Sticky

Discussion in 'Street/strip 400/430/455' started by got_tork, Jun 4, 2023.

  1. got_tork

    got_tork Well-Known Member

    Not sure if it is feasible but imo I think it would benefit members looking to upgrade,figuring out new combo/build,lost there's or bought a used cam.
    Chris
     
    got_tork, Jun 4, 2023
    #1
    rjay likes this.
  2. breakinbuick11

    breakinbuick11 Platinum Level Contributor

    I think it’s a good idea. I was going to start a thread looking for a cam card on the Schneider 290-10H that came in a motor I bought off of Facebook marketplace.
     
    breakinbuick11, Jun 4, 2023
    #2
  3. Bigpig455

    Bigpig455 Fastest of the slow....

    TA 288-94H
     

    Attached Files:

    Bigpig455, Jun 5, 2023
    #3
  4. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD" Staff Member

    I don't see why not.
     
    LARRY70GS, Jun 5, 2023
    #4
  5. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD" Staff Member

    I started a thread for Cam Cards and stuck it.
     
    LARRY70GS, Jun 5, 2023
    #5
    breakinbuick11 likes this.
  6. got_tork

    got_tork Well-Known Member

    Thanks Larry
     
    got_tork, Jun 5, 2023
    #6
  7. avmechanic

    avmechanic Well-Known Member

    I do not have the cam card for the 290-10H but I have some of the specs in this file if that helps.

    Screenshot 2023-06-07 at 5.57.14 PM.png
     
    avmechanic, Jun 7, 2023
    #7
  8. breakinbuick11

    breakinbuick11 Platinum Level Contributor

    thank you! I saw your chart in one of your old posts and appreciate the leg work. I also reached out to an email they had on their website and got this response:
    400/455 BUICK
    #05106
    290-10H
    INTAKE 290 DURATION 230 @ .050" .496" LIFT
    EXHAUST 310 DURATION 244 @ .050" .496" LIFT
    114 LOBE CENTER
    VALVE LASH HYDRAULIC .000" + 1/2
     
    breakinbuick11, Jun 7, 2023
    #8

Share This Page