Anyone have a need for this 72 back sheetmetal?

I was going to use this for the inner panels on the rear sides,but,it's just sitting here not doing me any good. The trunk on the driver side has holes but the middle and passenger side is ok.The rear filler panel is fair with a couple holes.The rear floor and the back seat panel appear fine. I am cleaning up and want it gone asap.If no one claims in in the next 2 weeks,I'll give it away to the junk man. You will need to haul it away as my truck is being worked on and I have no way to haul it.

 

Located in Loganton Pa, right off I 80

 

Make a sweet couch

 

You interested in letting the rear wheel well trim go?

 

Are you interested in parting it out at all?

 

That's a full rear clip in what appears to be in reasonable condition. And it is already up "there". I would make an effort to find the buyer up "there" who is in need of it. PA/OH/IN/IL. Value, since it's up there - $999? More? Good luck just my opinion.

 

I sure could use that drivers side 1/4.... living in the PNW has it's drawbacks at times..

 

I listed a full rear clip from a '71 four door some years ago. Well not quite as full as the one above. Was in a U Pull It. Was able/willing to sawzall the entire rear part of the car off. Absolutely no rust. The potential shipping costs killed any deals that might have been made.

 

how are the quarters on that thing around the wheel lips?