Sold. Excellent condition, all sealing surfaces in excellent condition, all threads in good condition. No rust. Date code from casting L-5 (December 1965 ). Oregon $1,000 lowered price to $800.
So the B262 is an aftermarket aluminum manifold manufactured by Edelbrock. I am sure it is a fine manifold. Probably make lots of horsepower. Mine is original equipment, cast iron and manufactured by GM in Dec. 1965.
Hey Suntreemcanic, Hope you mind my saying so, I've been watching your thread & I know you didnt ask, but, I just thot I'd thro in my .02cw, the intake is easier PART of the battle to put together a complete 2x4 nailhead intake setup, ie: correct carbs, linkages, trans switches & brackets and air cleaner are the most difficult pieces to locate... Just Say'n, IF you had those items to add to your listing, I think perhaps your intake would get more attention... Wheelz, Tampa Bay
Question: I see this intake is listed as a 1966 manifold. I have a few of these kicking around but it was always my understanding that the 1966 manifolds were spread bore for Rochester carbs....... or was it only single 4bbl?