68 Skylark 28-10.5

Discussion in 'Race 400/430/455' started by Skylard, Oct 10, 2022.

  1. Skylard

    Skylard Well-Known Member

    I'm working on fitting a 10.5 tire in a 68. I don't have the space n tool to narrow the frame rails, so I'm looking to push the fenders out. The outer wheel housing/tub and the lip on the fender are already removed.
    With the curve of the quarter panel, it's difficult to under stand how to cut it.
    Anyone have experience to share?
    Thanks
     
  2. hugger

    hugger Well-Known Member

    If you gonna butcher it up just take a torch and BFH to rails
     
  3. hugger

    hugger Well-Known Member

    Should have relief cut the lip and rolled it up,..sounds like you got a mess if you cut the lip off completely
     

Share This Page