I have a complete, running 401 with the ST 300 transmission that was originally behind it that was removed from a 1965 Skylark GS. This is an...
I recently stumbled on this car while looking for some parts for my 64. This thing ended up being in a junkyard, less than a mile as the crow...
I am looking for a Nailhead - 401/425 Engine Stand - Dolly for storage. Ant recommendations appreciated. Mark
I recently performed an HEI points conversion on my 1966 Electra, only with the help of you kind folks! I got to the point where all is hooked up...
Earlier, i had some HEI conversion issues about the exact thing I am going to describe. It turned out that the ignition coil was damaged within...
I installed an HEI distributor the other day and had the motor at 10-12 degrees before TDC. As i went to drop the distributor in, the rotor would...
Hopefully i am posting in the right forum area. I have looked everywhere and beyond for this diagram. I have most vaccuum lines attached, but...
Lou Santiago built the rear control arms for me.[ATTACH] [ATTACH]
Looking for advice. I have a 1966 Buick riviera with a 401 matched to a dynaflow out of a 1963 Riviera. Never came with a driveshaft. I'm not...