Selling my 1972 Buick 455 engine. Has been freshly rebuilt with clevite bearings, Hastings rings and Fel pro gasket set. Has factory bore size and mains and rod journals were turned down 0.010. It has a Poston S-divider intake and poston GS-116 camshaft with stage 1 valves and pertronix ignitor upgrade. I have a new in box water pump and new in box powermaster 9202 starter that will come with it if needed. It has about 20 min. Of runtime. Asking $1000 any questions feel free to ask. It is located in Longwood,FL. And sorry no shipping.
Interested, What the CR and did u video the startup? Oil pressure? And is crank drilled and block on left rear lower side have manual pivot ball threaded application?
8.5:1 compression, oil pressure was 25 psi at idle warmed up with 10w30 oil. No video unfortunately. There is a threaded blind hole on the lower left side near the bell housing and not sure what you mean by crankshaft drilled?.
Build was finished end of june and engine was running on 4th of July 2019. Was in my s10 until a tree fell on it and ended the project.
Wow, I could have made a short detour yesterday. I drove down 75 to Sarasota to deliver a car and came back with a empty trailer n truck.
Sorry for dragging my feet, I’m stepping off, thanks for details! Good luck sounds like a smokin good deal for someone. Be safe all.