Mike, I purchased Edelbrock heads about two years ago, due to a mould problem your were not available at the time. With these heads on my block my dip stick will not clear the header flange on my MT-headers, it is very close. Have you seen this problem, or know of a remedy short of cutting the flange? Mike R.
You either have to rebend your tube to fit, grind a notch in the header flange (or cut it out altogether) or try a TA 1500D tubeless dipstick.
Thanks Mike, I was looking at your new dip stick and it is too close for that to ! I guess its time to get the grinder out. You know it Bruce that is what I had on my mind when I posted this question.