What is the secret to install these monsters? o No: I figured I would try to kick start the finish of my resto and tackle this "small" project. Well, I have no idea how to do it. I have searched this site and Googled and have not found anything. This is for a '65 Skylark, and I am doing the windshield and rear window. Any help or guides you can provide is greatly appreciated. Joe
Joe, Hopefully the clips were installed prior to installing the windshield. Just assemble the frame so it completely surrounds the windshield as it is supposed to. Then press with your fingers or the heel of your hand on the edge of the trim away from the glass. It will snap down into the clip. Try not to apply pressure on the glass side edge as it could chip or crack the glass. I start at the upper left (driver's side) corner and work my way around the window to the top of the other side. I then alternate from one side to the other meeting and ending in the middle (of the top piece) where the 2 pieces overlap. It's not rocket science, nice and easy does it. Greg
Greg, Thank you very much for the response, I appreciate the assistance. I will let you know how I make out. Joe