Starting a frame off

Discussion in 'Wrenchin' Secrets' started by GS Rick, Aug 24, 2017.

  1. Bluzilla

    Bluzilla a.k.a. "THE DOCTOR"

    Here's another tried and trusted method I use when restoring Corvette Chassis. The straps have flat hooks on the ends that grab the rocker pinch welds. The block and tackle is attached to a large I-beam that spans the shop ceiling.

    scan0030.jpg

    Larry
     
    GS Rick likes this.
  2. eddie

    eddie Well-Known Member

    After almost dropping my body when i took it off using blocks and floor jack , I took some recommendations from some fellows here when I put it back on the frame I used the seat belt anchor points some 3/8 chain hooks bolted to anchor points and a 20 FT tow chain kept changing center hook until it was lifting equal with cherry picker through door opening doors not on body picked it up rolled frame underneath and lowered onto frame
     

    Attached Files:

  3. alain

    alain Well-Known Member

    :)Here is my 2 cents lots of buddies some beer to put back on frame repeat
    PS beer after work is done very importanto_O
    Alain;)
     

Share This Page