I have a set of used doors that I intend to have acid dipped to remove paint and rust before sending to my body man for primer and paint. I'm having trouble removing the latch mechanisms from the doors - they seem to be in there very tight! I've used my biggest Phillips screwdriver and plenty of PB Blaster, but haven't made any progress. I'm hoping for some advice, tips, tricks - anything to help. The doors have to be completely stripped before dipping, so I'm hung up on this until I figure it out. Thanks in advance, Darron
You need a #3 bit, they will never come out with a #2. An impact driver is best for this job. You can usually do them with a #3 socket type bit and a long ratchet. I don't like to recommend China tools, but you can get a cheap impact set for maybe 10-12.00 at Harbor Crap. One good bit/socket is maybe 8-10 up. http://www.harborfreight.com/impact-screwdriver-set-with-case-37530.html http://www.harborfreight.com/6-pc-12-in-drive-screwdriver-bit-socket-set-67881.html
I just did this. I used the biggest philips bit I had, in an adapter for my 1/2' ratchet. While pushing in on the screw with all my weight, They backed out nicely without stripping. Plus new latches I installed came with new screws (though they were the incorrect flat head, originals are pan head)
Thanks guys, I was trying with a #3 Phillips hand screwdriver. I'll go back to the hardware store and see what I can find for an impact screwdriver. Or a ratchet attachment.
If the screwdriver you have is a quality tool like Snap On, it will have a hex bolster on the shaft near the handle. You can use a wrench on that for more leverage. But...it's like Curtis said, you have to put pressure pushing + turning it at the same time.
It is an SK screwdriver, with a hex bolster. I'll give that a try. Of course, any excuse to buy new tools ....
