Rear Bumper Adjustment Tips?

Discussion in 'Wrenchin' Secrets' started by Paul Stewart, Mar 4, 2018.

  1. Paul Stewart

    Paul Stewart Well-Known Member

    put the new bumper on and I would like to tweak it a bit. Gaps are a little wide for my liking to the quarter panel.......

    This may be fine, or maybe not?
     

    Attached Files:

    Steve S and 1967 Big Buick like this.
  2. CJay

    CJay Supercar owner Staff Member

    Left side looks a little low, otherwise it looks as good as the factory made it
     
    FirstBuickNut likes this.
  3. Paul Stewart

    Paul Stewart Well-Known Member

    You were right Jason, had my oldest do a dead lift on both sides and was able to bridge both gaps. I am satisfied at this point. One nice thing the N-25 option gives you is full access to the upper bracket bolt! ;). Tightened everything up and calling it a day. Next is the custom 2.5” exhaust system made by the best exhaust company on the planet, Waldron Exhaust out of Michigan!

    http://waldronexhaust.com/
     

    Attached Files:

    Last edited: Mar 4, 2018
  4. wovenweb

    wovenweb Platinum Level Contributor

    White pants?
     
  5. Paul Stewart

    Paul Stewart Well-Known Member

    EFD59831-67E5-4240-A4DF-4A4506B95345.jpeg
    LOL, well my garage is a clean room?

    That would be a life-size cardboard STIG standing next to Speed Racer. Every garage should have them!
     
    FirstBuickNut likes this.
  6. wovenweb

    wovenweb Platinum Level Contributor

    Lol, okay that makes much more sense.
     

Share This Page