The little pins where the wiring harness plugs onto the back of the gauge pod were bent, only one was bent bad and it was almost broke I straightened them out but I figure when I try and plug the wiring harness back on the one pin that was bent badly will break off... Any help appreciated. The plastic lens cover appears to be very clouded, the tach and speedometer lenses both look OK compared to the gauge pod... Hope this is decipherable... How can I fix this or where can I get it fixed?
I would solder the bent pin for security. Gauge lens may clean up with Meguiar's #10 Clear Plastic Polish. Also, The Parts Place may be selling repro lenses(?)
Thanks for the help Thanks, I am going to try and get a speedometer shop to try and straighten/solder the pins. I have a parts car that I took the cluster out of, it has some good lenses. Can I just bend the little tabs back and swap them?