Quarter Panel Part

I'm not sure if anyone can help me with this, but I need just a part of a quarter panel. It's for a 68 GS400. Mine is badly rusty, and I would like to try to get a piece to weld into it to fix it. Maybe someone is parting out a 68 that the quarters are shot belowo No: All I need is the corner that is damaged.
Thanks
Dan:3gears:

 

Another Shot

 

1 More

 

Check THIS thread. They are parting out a 1969 Buick GS 400. Goodluck.:TU:

 

Hi Dan,

your a week late,i had 2 full 1/4's from a 69. and i got tires of looking at them and took them to the junk yard.
i'll check to see if there still there tommorrow. Michael

 

Yes please let me know if they are still around (not melted down yet)
Dan:3gears:

 

hey michael if they are still around if dan only needs the drivers side i could use the pass. side :Brow:

 

are they the same on a 4 door?
if so, i have both sides still on a car
i can cut off. how far forward from the
rear do you need?

 

All I need is what is pictured above in this thread. I can get some measurements tomorrow. I would think they would be the same there for a 2 door or 4 dooro No:
Thanks,
Dan:3gears:

 

i cut this off today

 

2

 

3

 

last

 

That looks like the part I need:Brow: How far up from the end did you cut that 1o No: I think I need 13" or something like that. I will be happy with just the end though. That would be the hardest part to fix. Any idea on a price and shipping to NYo No:
Thanks,
Dan:3gears:

 

i need the piece that the trunk lid seals to. you can have the
piece you need for the shipping if you want it. there is a dent
in the sharp crease and a little surface rust but no holes.
let me know how much of it you want and i'll cut it and find
out how much to ship it.

 

I mayhave another parts car to get somemore from if you all need other sections.......

 

I need the piece of the quarter panel for the drivers side. Can you give me an idea of what you need for the trunk seal so I can see what will be left at the topo No: Then I can guess how it will match up with what I have already. I'll also check my other side to see if there is any fiberglass under there too. Thanks.
Dan:3gears:

 

I have another car to part if you still need a section.The lower part is rusty but the ends like the above pic is good...

 

is this enough?
do you need both sides.

 

That looks like it would work. Could you post another picture of the other end so I can see. I'll check the other side to see if I need both and let you know later today.
Thanks,
Dan:3gears: