Power steering pump pulley

Discussion in 'Parts wanted' started by jzuelly1, Jan 20, 2019.

  1. jzuelly1

    jzuelly1 Jesse Zuelly IV

    Anyone have a single groove power steering pump pulley they would sell?

    The one on my old one is a bolt on type, the bolt isnt moving yet. Putting a new pump on and need a pulley.
     
  2. Donuts & Peelouts

    Donuts & Peelouts Life's 2 Short. Live like it.

    For what engine
     
  3. CJay

    CJay Supercar owner Staff Member

    You need to use an impact on that bolt. Once the bolt comes off the pulley should come right off
     
  4. BrunoD

    BrunoD Looking for Fast Eddie

    Like Jason stated,if you do not have the tools,or the compressor,just go to the machine shop or mechanic you deal with,it will only take a couple minutes to do the job.Bruno.
     
    woody1640 likes this.
  5. jzuelly1

    jzuelly1 Jesse Zuelly IV

    Does it matter that it is off the car? The old pump is crap so can I crank it down in my vice and use the impact to bust it off?

    If not I can bolt it to one of my engines I suppose.
     
  6. CJay

    CJay Supercar owner Staff Member

    You don't need to bolt it on an engine or put it in a vice. Doesn't matter that its off the car. The impact will take it right off. Wear a glove and hold the pulley so it doesn't spin.
     
  7. ToddsGS

    ToddsGS Founders Club Member

    IF you end up needing a pulley I do have some. . . .
     
  8. jzuelly1

    jzuelly1 Jesse Zuelly IV

    I got it. I'm new to air tools. Pretty awesome. Thanks to all.
     
  9. Buickrat1

    Buickrat1 Well-Known Member

    I have a pulley as well.
     

Share This Page