Hi from Tampa, I ordered a headliner for my 2-door 65 skylark sedan from some seller on ebay (haven't opened it yet), and I tried to get the trim bits from OPG. It was a hassle frankly. After 2 very long phone calls, I think I need these parts from OPG, if you could let me know if this is right, it would be most appreciated. *Windlace...runs up the sides of the headliner, over the vent window/door window, rear window. Rubber U-shaped pieces. *Headliner seal, a black plastic piece which runs over top of the front windshield. But what goes in the front corners of the windshield? OPG isn't sure. There is a screw hole in each front top corner, which I think probably held some chrome thingy in? *Rear windshield....looks like the same headliner seal, and it runs over top the rear windshield as a straight long piece, then you trim another piece to make the two side pieces. Next, there are two corner pieces at the top corners of the rear windshield, and, there appear to be two bottom corner pieces at the bottom of the rear windshield. Total of 7 pieces for the rear windshield. *They sold me a "coupler" piece as well, which looks like it would cover the joint where two pieces would butt together, but I can't figure out where a butt joint would occur. Any advice would be most appreciated. Rich
