One turn signal works after frame off

Discussion in 'Sparky's corner' started by sailbrd, Jul 20, 2018.

  1. sailbrd

    sailbrd Well-Known Member

    I am usually pretty good at wiring but this one is getting to me. Did a frame off over the last year. This was to done to clean and upgrade frame and install new body cushions. Did not really touch touch body from firewall back. Car has had complete replacement of wiring with American Autowire system. I did do a plug disconnect for the front lights. Headlights are on relays.
    1. All running lights and headlights work.
    2. Right front turn signal works.
    3. Emergency flasher only works on right front.
    4. Put in new flash can
    5. just noticed turn signal stalk does not feel right when trying left signal
    6. when I check the working light I get solid 7.5 volts on the blink side
    7. on the "bad" lights the voltage fluctuates from 12v to less than 1.

    I can see where I could have messed up the front with the disconnect plug but the rear wiring was never touched.

    Ideas appreciated.
     
  2. LouV

    LouV Silver Level contributor

    Does the brake light work? Does the left parking light work? Check the wiring from the flasher out, probably a problem around there going to the lights.

    Good luck.

    Lou
     
  3. sailbrd

    sailbrd Well-Known Member

    no brake lights, only light that will blink is right front. Going to put in new signal unit in the steering column.
     

Share This Page