Ford 9" measures 36 1/2" end to end, has Big Ford Ends, width between ladder bars is 17 1/2". Comes with Alston 32" Ladder Bars. Axles are Strange 35 spline, 5/8" studs and nuts, 4 3/4" bolt pattern, axles are 19" and 22" flange to end of axle. Rear end come with back brace, wheelie bar brackets, shock mounts, third member studs and nuts ( third member not included) spool is Strange p/n D1555 and is 35 spline w/ bearings and races. Also comes with Koni SPA1 coil over shocks, shock mount width on rear end is 17 1/2". Wheelie bars are A.R.T. units that are already welded and are 87 1/2" Long and 24" wide. All these parts came off my car and were used as mock up ONLY. I switched to a fabricated rear end so I am selling. This set up came off my 67 Skylark which was set up for 33×16 slicks. I would like to get $1500 if possible and I would rather not ship if possible as it would probably cost a fortune to ship may even have to go by truck? I live about an hour south of Chicago 60914. Thanks. Lawrence
This people...is a screaming deal! I paid almost double the asking price for my rear alone from S&W...
Not off the top of my head, are you talking everything? I would have to weigh everything separately...
Ok, it was a bit awkward but I stood on a house scale and subtracted my weight while holding each part... Rear end = 51 lbs Ladder Bars = 20 lbs Axles (pair w lugs)= 30 lbs Spool w bearings and races= 7 lbs Shocks=20 lbs Wheelie bars I am guessing maybe 30 lbs as they were too big to weigh and they are chromoly Also, I really don't want to seperate because the axles were made for the rear end and if I seperate no one will buy piece parts
Ok,sounds good. I still need to get out in the shop and measure mounting points and total width. I'm so hoping it works.my housing has seen better days. I have a 35 spline center section already.
Ok I finally had time to measure. Mines 39 1/2 wide and all the mounts are off too,so I'm out. Dam wish it would have worked. That's a sweet deal. Next!!
Looks like it's up to me...sorry it won't work for you Dan. I'll try to measure mine later today or tomorrow. I know it's a narrowed 9" with a four link but not sure how much room to move.
Well, as much as I wanted this to work I'm in the same boat as Dan. We must have the same set up. I'm 40" backing plate to backing plate: this one is 36 1/2" Shock mounts on mine are 22": the one for sale is 17 1/2" My Wheelie Bar mounts are 16" and so are my front ladder bars: this one is 24" wide. It's a excellent deal but I'd rather not have to change or re-design everything. My drag car hooks and I really like it that way! Good Luck, I'm out... Philip T.