Distributor gear

Discussion in 'Small Block Tech' started by Buick#455, May 10, 2019.

  1. Buick#455

    Buick#455 Well-Known Member

    Can I use a gear off of hei distributor & put it on my msd pro-billet distributor?
     
  2. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD" Staff Member

    I doubt it. Not sure of the shaft diameters. They might be different.
     
  3. Buick#455

    Buick#455 Well-Known Member

    Hmmm, I'll check it out, but I can't seem to find any gear replacements for my msd pro bullet, PN 8548 anywhere......
     
  4. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD" Staff Member

    I would call them. 1-888-258-3835
     
  5. Mart

    Mart Gold level member

    Jegs or Summit did not have any listing for that gear when I bought mine. I called MSD direct to order, they should have a part number for that replacement gear by now. IIRC it was abt $35 - 45 shipped.
     
  6. Fox's Den

    Fox's Den 355Xrs

    Again, not much support for our 350's
     
    Mark Demko likes this.
  7. Mark Demko

    Mark Demko Well-Known Member

    Yep, were pretty much on our own to "figure it out":rolleyes:
    I like being the underdog, the only way from there is up!
     
  8. Fox's Den

    Fox's Den 355Xrs

    up all right, straight up. no rocks to climb on.
     
    Mark Demko likes this.
  9. Mark Demko

    Mark Demko Well-Known Member

    When I bought my MSD Pro Billet distributor Im pretty sure it came with the gear, and a stock gear would fit if neededo_O
     
  10. Mark Demko

    Mark Demko Well-Known Member

    LMAO:D:D
    You got that right!
     
  11. sean Buick 76

    sean Buick 76 Buick Nut

    Yes you will need to call them. I bought a used Msd 455 Dist. Then I called Msd and bought a 350 gear for it.
     
  12. Gallagher

    Gallagher Founders Club Member

    What are you talking about?

    Replacement Distributor Gears
    TA 1400 350 Bronze, Points ...................... $35.00
    TA 1400A 350 Bronze, MSD ........................ $45.00
    TA 1400B 350 Bronze, HEI .......................... $45.00

    TA 1402 350 Steel, Points ......................... $65.00
    TA 1402A 350 Steel, MSD ........................... $69.00
    TA 1402B 350 Steel, HEI ............................. $69.00
     
  13. Fox's Den

    Fox's Den 355Xrs

    I guess I should have looked first? lol There is still not a lot of support for this motor, Heck I had my heads ported 24 years ago, you would have thought some aluminum heads would have been done before now.

    Those Ken Bell test are 30 years old and it just dies off after that. You still can't go down to Summit to get any parts for a 350. I got some there but not a whole lot.

    Nobody has matched Sonny Seal yet.
     
    Mart likes this.

Share This Page