I have the later 70s console plastic and used the step by step instructions by George Nenadovich on another web page. The measurements do not come out correctly. I will not cut it until I get it right. Anyone have a template or could create a template for me? Here is what it looks like after I draw it out.
Send me your address as well in the PM I sent about the Lincoln seat module. I was in the same predicament and traced the outline of a 1970-1972 console on cardboard. Will trace onto a long sheet of masking paper and send with the module, if it is correct one. Two bird in one stone! Your lucky day!
Big shout out to Steve for his help. I was going to cut the 70 and up center plate, but I decided to make one. Here it is in fitting.