Clutch decision time...need some "chatter" here....no pun intended, let's

Discussion in 'U-shift em' started by moleary, Feb 13, 2016.

  1. standup 69

    standup 69 standup69

    flywheel pic/ old track shot
     

    Attached Files:

  2. moleary

    moleary GOD Bless America

    Thanks, that is exactly what Rob said and I shift at 5300 rev limiter 5600...

    Your build is very impressive! Good Job!
     
  3. 8587GN

    8587GN Well-Known Member

    bringing up an old thread..........asking the same questions. I just bought an Autogear M22-W [ saving the numbers M21] for my Stage1, the engine is a 494, that were killing the compression down to be pump gas friendly. The car will never have slicks/drag radials on it, just the G-60`s. So for what I`m doing, is this Centerforce a good choice ?
    Centerforce DF148552
     
  4. alain

    alain Well-Known Member

    :)Looks like the logical choice for street use;)
    Alain
     
  5. moleary

    moleary GOD Bless America

    I had a reason to revisit this thread today and figured I’d update it two years later. I have since swapped out the M22 with a M23 and the warranties McLeod is still doing fine.
     

Share This Page