Brake Master Cylinder

Discussion in 'Race car chassis tech' started by JEFF STRUBE, Jun 4, 2006.

  1. JEFF STRUBE

    JEFF STRUBE Well-Known Member

    I have a Strange one will not work the stock Studs. Stock studs are wider in the fire wall than the strange Master Mounting.

    Witch one fits with out any Mods.

    Will any of the WilwoodS fit with the stock studs.

    My Car is a 70 GS
     
    JEFF STRUBE, Jun 4, 2006
    #1
  2. badbuik

    badbuik Well-Known Member

    Jeff, I have a Wilwood one on my '65, no, it didn't line up witht the stock studs. I cut them off, and redrilled the holes, then welded the new bolts in. Good luck.

    Gary G.
     
    badbuik, Jun 5, 2006
    #2
  3. 10sec 455

    10sec 455 Well-Known Member

    Jeff,
    I just slotted the master a bit. On my 68 car I have an S-10 master. The studs line up on that, but you have to enlarge the hole in the firewall for the master bore.
     
    10sec 455, Jun 5, 2006
    #3
  4. Dubuick

    Dubuick CMDR Racer

    I used one for a 69 corvette four wheel manual disc brakes it works great bolted right up :TU:
     
    Dubuick, Jun 9, 2006
    #4

Share This Page