1967 GS400 hardtop part out

Knobs, windshield washer parts sold. Still haven't removed wheel well molding as the screws started to strip. Console is still in place due to a stripped screw on the shifter section. Will try again this coming weekend.

 

vinyl top trim has no price?

 

How about $60 for the rear vinyl top trim (both sides), $100 including the drip rail trim. Plus shipping. I don't have the windshield or rear window trim.

 

Stacey I may be interested in the Radiator top pieces and will let you know hopefully tomorrow if I can stand the single digit temp and take a look at my station wagon (sitting under cover outside) radiator pieces and compare them to the GS400 in the warm garage. If not the same as GS then I am interested in yours.

Chuck

 

Interested in rear wheel molding if you have to break them up to sell them ? Really only need right side. Thanks Ron

 

Did the console come out yet?

Still interested in the condition of the floor pass through plate

 

Stacey, due to the cold weather did not make it to the station wagon today but will tomorrow for sure.

 

I may need the top radiator plate Stacey, do you know if that is a 67 GS400 only part ?

 

Sorry not yet, The screw on the PRNDL part of the console is stripped so I haven't gotten pulled it yet. You are on the list, just haven't there yet. Every rusty bolt on this thing is fighting me.

 

Chuck Nixon is in line first, if he wants it. The top plate has wider rubber pads on big block cars to accommodates the thicker radiator that came with a GS 400. I have a small block top plate too so I can take a picture of both parts side by side to show you what I am talking about.

 

Any word on chuck taking the top plate? can I get a picture of where the shroud corners meet with the plate

 

I will try and get over to the garage tomorrow and get some photos.

 

Choke spring still available?

 

Nope, it's gone - Sorry.

 

Frame brackets for motor mounts?

 

Rhett - is that fancy little plate what you are looking for? It has surface rust but appears solid. How about $30 shipped in the lower 48.

 

Thanks stacey, let me know

 

Hi Chuck - you interested in the top plate? Let me know, Joe is interested in it as well. Additional photos are below. The painted part is a small block top plate for comparison purposes so you can see the differences in the radiator pad area.

 

I didn't pull the engine today but the motor mount brackets look good from what I can tell. I will PM you when I get them out of the car.

 

That one has the same flat spot as the one I currently have. going to pass. looking for one like nick has on his car.
Thanks Stacey