I'm diving down the "while I'm here, I might as well" rabbit hole. I have a good little 1965 300 that ill be driving till the new motor is ready...
I'm not sure if everyone is already aware but... Over on the MG Experience Forum Brian MacMillan, Jim Nichols, and Anthony Laney in Australia...
I'm wondering if my car is rare... (I know I'm not the first!) But after searching the internet for weeks I have found only ONE other YC paint...
Same story, looking for a 1965 cast iron 4bbl intake. Thank you.
I'm looking for a pair of original or nice aftermarket valve covers for a 300 V8. If you have a set, please let me know. Thanks in advance, Matt
I am in Helena Alabama, 35080. Hello, I recently purchased a 4 speed muncie package and can't use some of the parts from the package. These...
I have 300ci 2bbl out of a '66 Skylark and I am looking to convert to 4bbl - looking for a manifold. Thanks for checking - Mike
Hello fellow Buick people, I've got a '65 Lark. Owned since 2000. Came with the a 300-4V. I mashed this engine until it really didn't sound good....
Does anyone know how many teeth are on the distributor for a 300 engine? I know the 350 has 14 teeth, I just need to make sure I can use my 300...
I'm sure it's been talked about before....I have a skylark with 310 wildcat(300)...converting points to HEI.....I know I need to run a 12 guage...
Hi, does anyone know if a 300 harmonic balancer will fit a 350 engine? Please let me know if anyone knows. Thanks.
After 14 years of sitting it out, I have decided to take my Special back on. My daughter is now old enough to go to school, and the time is...
I check with you guys for everything from under the hood to the brake lights. I'm about to check my spark plugs because I'm being told by my...
So, I made a mistake and forgot to take a few pictures of the spark plug wires before I pulled them off. I wanted to know if someone could please...
Hey guys, it's me again. This is my first rebuild and I think I'm doing ok. I'm still seeking advice and tips. I bought a new: 1....
I Got A Rare 1964 Buick Lesabre 2 Door Hardtop Only 24Xxx Made, I need Help Finding Parts For The Beast, I Could Use Both Outside Rear Bumpers The...
I want to build a stroker engine and need a Buick 300 crankshaft and was wandering how much a shaft might cost. I can use a standard or oversize...
Im selling a used set of Poston Headers that were made for 64-67 300/340 engines 6+ years ago. These are pretty rare and hard to find these days,...
405-819-0475...click on my profile for pics....still trying to figure how to ad pics to thread:rolleyes: http://youtu.be/TsqVtSb31QU...