1/2” stainless fuel line

Discussion in 'The Mixing shop.' started by BrianTrick, Dec 5, 2017.

  1. BrianTrick

    BrianTrick Brian Trick

    I’m not sure where to post this,but I just got my 1/2” stainless pre-bent fuel line for my silver car. I’ve a variety of these made for various projects,by Inline Tube. I just figured maybe someone else was looking to get one,or wondered if anyone made them. Inline Tube will make them,special-order. This was $176.00 with the shipping to my house. It come bent in a large “U”. If you see the white bands in the pictures,that is where they bend it for packaging,and you just gently flatten it back out.
    This is good for anyone running a RobbMc 1/2” sender,and a big mechanical pump.
     

    Attached Files:

    TrunkMonkey likes this.
  2. hugger

    hugger Well-Known Member

    I didn't know they were doing them in one piece now, Ive always gotten them in two piece, but yea they can even do 5/8 I believe
     
  3. 87GN_70GS

    87GN_70GS Well-Known Member

    I had my 1/2" made there, but it had a rubber hose section in the middle
     
  4. TrunkMonkey

    TrunkMonkey Well-Known Member

    I got a 3/8" body line for my 1964 Skylark from them.
    Inserted the front through the frame and used a pull wire to assist and pulled it about 2 feet beyond the normal point, and then was able to bow the center and get the back in place.

    It was actually easier than the body brake line.

    Very happy with Inline Tube.
     
  5. 8587GN

    8587GN Well-Known Member

    Fine Lines in Wadsworth,OH can do 1/2" lines as well
     
  6. izanurse

    izanurse Platinum Level Contributor

    I’m just about to buy fuel line for my Stage 1. This will be perfect, thanks for posting this.
     

Share This Page