70GS Ride Height

Discussion in 'The whoa and the sway.' started by josehf34, Dec 4, 2018.

  1. gstewart

    gstewart Well-Known Member

    Cars from the factory normally were lower on the rear end.
     
  2. DasRottweiler

    DasRottweiler -BuickAddict-

    12lives likes this.
  3. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD" Staff Member


    Nahh, I enjoy it. That's what V8 is all about. Been here so long, and my memory is still pretty good. Just have to find the thread/post where I said it before.:)
     
    docgsx likes this.
  4. josehf34

    josehf34 Well-Known Member

    Sorry guys, I was outside of the country enjoying my vacations so haven't had time to check the issue with the height. What I can tell you after I sent the car to the align shop is that both front springs are the same and doesn't have any paint stripe, also in the rear I can confirm I have the spacers (the align shop guy confirmed me that) but unfortunately I think I can not remove them or the new tires are going to hit the quarter panel
     
  5. Doo Wop

    Doo Wop Where were you in '62?

    Sheesh, what size are your tires?
     
  6. josehf34

    josehf34 Well-Known Member

    Front are 235/60R15, rear are 295/50R15 and all tires are touching the body :confused:, the rear are touching the quarter panel so I'm not sure how to deal with it, but the front are touching the inner fenders when steering and that's on both front wheels, when bough the tires I tough 235s on the front weren't going to be an issue but looks like they are :(
     
  7. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD" Staff Member

    What wheels are you using? Do they have the correct back spacing? Or is the suspension height too low?
     

Share This Page