Hey still have parts left? I need about 1/3 of the passenger quarter panel if you're willing to chop it. From about, mid wheel well back. Also looking for a trunk lid (Don't care if it's rusted so long as it's straight) and a rear bumper. Need the trunk latch as well, not the part on the lid, the part in the trunk itself.
Hey Mike, If you decide to tear apart the rear end, I need a useable axle shaft. Does anyone know if the convertible shafts were beefier than the coupes? Thanks,
Hinges? make me an offer. I got this and once again wil entertain offers Here is the pictures of what I have I have a 4 door I can pull an axle from They are all the same as far as I know. I have been selling axles for $40 plus shipping. Which side did you want?
Not sure if the side matters to me. I may take both sides to have backup. The reason I asked if there were differences is that I recently bought a '66 axle that seems to be tapered significanlty thinner toward the splines. The axles that came out of my '67 convertible were not tapered and seemed to be the same thickness all the way to the seal. The idiot at the machine shop I had pull the bearings left me with a nice gouge on the seal surface. Can you snap a few pics including a close up shot at the inner splines? Thanks,
Hey Mike, Do you still have the trunk letters? Also looking for the grommet between the power booster and the master cylinder. Have a pic if you need to see what I am looking for. Thanks
Hey Mike, Those may be it. See the attached photo. The axle on the right measures 1 1/16 where the caliper is. The one on the left (from the '67) measures 1 3/16 at the same location. Can you let me know what yours measure? And can you estimate shipping for both to 33407 (West Palm Beach, FL - business address)? Thanks!
OK Mike, I know I am bordering on annoying (if not already there), but can you confirm that the seal surface is ok on both of them, and that they have the rw-507-cr bearing installed? Also, can you quote shipping to 33407 West Palm Beach, FL for both? Thanks,
$35 for the shipping And I cant see any seal here is what I see. The bearings are in excellent condition as far as I rolled them and feel nothing that would say they are bad. No wobble or looseness
Still have the Manifold? If so let me know a price on that and the rear bumper shipped to 93722 Also, have you got the keys for the door and trunk locks? If so give me a price on the locks and keys as well.
The engine is complete and it runs Im selling it that way. Rear bumper is bent you saw that right? Will see what I can do about getting pictures today for you.
Mike, What would you be looking to get for the arm rest backing plates? and the seat belts if they are for sale? Brian